Preview

Membrane Behaviour Lab

Good Essays
Open Document
Open Document
1571 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Membrane Behaviour Lab
Membrane Behavior Lab

Abstract:

Introduction:

The permeability of a cell to solutes in an aqueous medium depends upon the physical and chemical make–up of the membrane. The maintenance of the living cell depends upon the continued presence and functioning of a selectively permeable membrane. If the nature of the membrane is changed or altered in any way, this may well affect its permeability and thus the properties of the cell of which it is a part. Irreversible changes in the permeability of the membrane usually lead to the death of the cell. In this experiment, you will study the effect of changes in environmental conditions on the permeability of living beetroot cells.

Materials and Equipment:

Scalpel
Tweezers
Safety Goggles
Cork Borer
3-4 Beetroots
Small Beaker
Test tube Rack
7 Test Tubes (The Effect of Heat)
Hot Plate
10ml of 0.1M HCl
10ml of 0.01 M HCl
10ml of 0.001 M HCl
10ml of 0.001 M NaCl
10ml 0f 0.01 M NaCl
10ml of 0.1 M NaCl
10ml of tap water
9 Test Tubes (The Effect of pH)
Graduated Cylinder
6 Discs of Frozen Beetroots (3 per experiment)
10 ml of Acetone per experiment

Procedure:

The Effect of pH

1. Top and bottom of beetroot were cut off by scalpel. The cork borer was used to cut out about 3-4 cores, then each core was cut into uniform discs about 2mm thick.
2. Discs were rinsed in a small beaker of cool water for about 5 minutes.
3. Each stock solution of HCl, NaCl and tap water were measured in a graduated cylinder to 10ml, then poured into individually labeled test tubes.
4. Three beetroot discs were placed in each test tube with tweezers.
5. After 40 minute of waiting the colour and intensity was recorded.

The Effect of Freezing

1. 10 ml of room temperature water was measured with a graduated cylinder and poured into a labeled test tube.
2. Three frozen discs of beetroot were placed into the test tube of room temperature water.
3. After 40 minutes of waiting the colour and intensity

You May Also Find These Documents Helpful

  • Satisfactory Essays

    Beet Lab

    • 578 Words
    • 2 Pages

    The purpose of this lab was determining the effect of surface area on the beets ability to interact with the environment. Three similar sizes of beets were assigned. Each beat was cut up into different sizes as one large piece, two smaller pieces and eight tiny pieces. All three different slices of beets were placed in their own containers and tested.…

    • 578 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    alcohol solutions used in this experiment are clear. If the beet pigment leaks into the solution, it…

    • 476 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    The permeability of membranes can be altered in several ways. From previous preliminary work I know that reagents, for example detergents and alcohol alter the arrangement of the phospholipids in the membrane allowing substances to leak out of the cell. Temperature also affects the membrane. As membranes relay on protein molecules to allow molecules to enter and leave the cell through facilitated diffusion the temperature must not exceed the approximate temperature of 50°C as at roughly this temperature proteins are denatured. This is due to an increase in kinetic energy making atoms in the protein to vibrate more; this breaks hydrogen and ionic bonds. These proteins will then not be able to function correctly within the membrane and permeability will increase, as substances are able to move more freely out of the cell. The temperature at which cell membranes are placed at also affects the phospholipids bilayer in the cell; this is due to the fluidity of the membrane. A cell membrane will remain fluid as the temperature around it decreases until it reaches a critical temperature at which a membrane solidifies, due to its fatty acid composition. This means that at temperatures below this critical point no dye in the beetroot cell would be able to leak from the cell and would not change the colour of the surrounding water. The phospholipids also undergo phase changes at higher temperatures causing the membrane to be more permeable thus allowing the red pigment to move more freely into the water surrounding the beetroot.…

    • 1919 Words
    • 6 Pages
    Powerful Essays
  • Better Essays

    Osmosis Lab Report

    • 1250 Words
    • 5 Pages

    The purpose of this experiment was to test different solute concentrations on the rate of osmosis. Artificial cells were filled with different solute concentrations and placed in water and weighed at equal time intervals to show how the water moves across cell membranes and down its concentration gradient into the lower concentrated area. The weights of the cells were recorded each interval, and then the rate of osmosis was found by calculating the corrected cumulative change in weight. The prediction made was that the cells with the higher solute concentrations would have a higher rate of osmosis and the cell filled with water and placed in 40% sucrose solution would have the highest negative weight change.…

    • 1250 Words
    • 5 Pages
    Better Essays
  • Good Essays

    Purpose: Examine the role of the cell membrane in the cell by disrupting its function using temperature (Biology 107 Laboratory Manual 2014). This will improve the general understanding of optimal growing temperatures and the breakdown of the cell membrane Procedure: Betacyanin solution of a known concentration was diluted to create a dilution series, then placed in a spectrophotometer set to 525 nm. The absorbance of the dilution was used to create a standard curve for betacyanin. Discs of living beet roots were then placed in water and exposed to various temperatures. A sample of the water that the beets were in was taken and absorbance was determined by the spectrophotometer and concentration from the standard curve for betacyanin.…

    • 639 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Beet Lab

    • 836 Words
    • 4 Pages

    For the lab experiment for testing the stability of beet cell membranes using pH, many materials were used as follows. Obtaining a beet we punch out cores, using a cork borer. After washing the cores we put each one inside a separate test tube, and added a different pH solution in each one. After 3 minutes in these exposure solutions, we took the beet out with a dissecting needle. Then transferred each beet to a separate test tube containing deionized water. After 20 minutes in these diffusion solutions, we took the beets out with a dissecting needle and discard it. We then stirred each solution in the test tube with a stirring rod, and transferred it to a cuvette. A spectrophotometer was then calibrated, and used to measure the absorbance of each exposure solution, and diffusion solution.…

    • 836 Words
    • 4 Pages
    Good Essays
  • Good Essays

    1. Use a cork borer to cut some beetroot tissue into discs about 3 mm thick.…

    • 567 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Beet Cell Membrane Lab

    • 805 Words
    • 4 Pages

    I really enjoyed doing this lab experiment and am excited for more experiments. The key part about having a successful experiment is to be well organized. Before I started I made sure I had everything out that I was going to need. Next, I wrote down my hypothesis for each piece of beet in the different temperatures. I cut up the beets into 6 exact pieces that would fit into test tube. Then, I labeled each test tube so I didn’t forget which one was which. I ran water over the beets in a beaker for 2 minutes to get the betacyanin off from the damaged cells. Next, I put one beet piece in each test tube. Now that I was set up it was time to start the experiment. I placed tube 5 in the refrigerator and tube 6 in the freezer for 30 minutes. While waiting for those to sit, I moved on to the hot treatments. I started off by using hot tap water to see if the temperature was 70 degrees Celsius. The temperature was a little low so I placed the beaker in the microwave foe a few seconds and checked the temperature again. Then, I placed the beet from tube 1 into the beaker of water for one minute. After one minute, I placed the beet…

    • 805 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    Another factor that I will be controlling is the surface area and mass of the beetroot pieces used. This is because the surface area affects the rate of diffusion, thus…

    • 2452 Words
    • 13 Pages
    Powerful Essays
  • Satisfactory Essays

    Beet Cell Lab

    • 452 Words
    • 2 Pages

    *Cut 4 uniform cylinders of beet using a cork borer with a 5-mm inside diameter. Trim each cylinder to 15-mm in length.…

    • 452 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    Beetroot Experiment

    • 1931 Words
    • 8 Pages

    The aim of the experiment that was carried out was to see, at what temperature and in which standard solution, does the amount of dye left in the boiling tube had the highest percentage transmission. Beetroot was used for the experiment because it was easier to see the dye after the practical was completed. Putting beetroot cylinders into different boiling tubes, which contained three different standard solutions of Ethanol, they were left for half an hour at a certain temperature to get the dye out. Once the time was up, the solutions was added to cuvettes and inserted into the colorimeter to test how much light was passed through the sample.…

    • 1931 Words
    • 8 Pages
    Powerful Essays
  • Better Essays

    If we look at the internal structure of beetroot, it will be observed that it consists of cells which are surrounded by a cell membrane. This cell membrane structure separates the contents of the cell from outside. The membrane has tiny holes in it which allows small molecules to pass…

    • 1772 Words
    • 8 Pages
    Better Essays
  • Good Essays

    The beetroot discs will be placed in distilled water at different temperatures. You will compare the intensity of the beetroot pigment that has leaked out from the cells subjectively and possibly objectively using a colorimeter. You can relate the findings to the effect of different temperatures on the permeability of cell membranes in beetroot (as well as in other organisms).…

    • 1515 Words
    • 7 Pages
    Good Essays
  • Better Essays

    Beet Cells

    • 1208 Words
    • 5 Pages

    Introduction: A cell membrane of a beet (Beta Vulgaris) is made up of a phospholipid bilayer with embedded proteins and cholesterols. The membrane is responsible for organizing the cell, protecting it from the exterior environment, as well as responsible for regulating what goes in and out of the cell though it’s protein channels and “selectively permeable” bilayer. (Campbell, Reece, Taylor & Simon, 2006, p. 79-80) When this membrane is damaged the reddish color, betacyanin, of the beet leaks out into it’s surroundings. (Online lab #1, n.d.)…

    • 1208 Words
    • 5 Pages
    Better Essays
  • Powerful Essays

    To investigate the effect of different organic solvents, such as alcohol and paraffin oil, on the cell membrane of the beetroot by using the red pigments in the beetroot as indicator.…

    • 991 Words
    • 4 Pages
    Powerful Essays