Molar Volume Lab Report

Good Essays

Open Document

Open Document

View Writing Issues

501 Words

Grammar

Grammar

Plagiarism

Plagiarism

Writing

Writing

Score

Score

Molar Volume Lab Report

Introduction
Molar volume is the name given to the volume that one mole of any gas occupies at standard temperature and pressure. In chemistry, many of the materials worked with are gases. It is often easier to measure the volume of a sample of gas, rather than determine its mass. The main purpose of this lab is to determine the molar volume of hydrogen gas experimentally in order to compare it to the theoretical molar volume of ideal gases. In this experiment, a known mass of magnesium is reacted with an excess amount of hydrochloric acid to produce hydrogen gas. The amount of hydrogen gas produced is collected by the displacement of water. This volume is used to calculate the molar volume of hydrogen gas. This data can then be used to compare the experimental molar volume of hydrogen gas and that of ideal gases at STP (standard temperature and pressure), by first using the Combined Gas Law (P1V1/T1=P2V2/T2) to find the experimental molar volume at STP, followed by the Ideal Gas Law (PV=nRT) to find the molar volume of any gas at STP. The partial pressure of the hydrogen gas must be found before the combined gas law can be used. It is found using Dalton's Law of Partial Pressure (P=PH2+PH2O). …show more content…
Ideal Gas Law: PV = nRT (101.3 kPa)(V) = (1 mol)(8.314 L.kPa/mol.k)(273 K) V = 22.4 L
Used to find the molar volume of any gas at

Continue Reading

You May Also Find These Documents Helpful

Better Essays
Gas Stoich Honors
- 910 Words
- 4 Pages
Gas Stoich Honors

11. Cover the hole in the stopper with your finger and transfer the tube to a large cylinder filled with water. Lower or raise the tube until the liquid level on the inside of the tube is the same as the outside. Record the volume of the hydrogen gas inside the gas collection tube. (Be sure to read the liquid level at eye level.)…
- 910 Words
- 4 Pages
Better Essays

Read More
Good Essays
Week 4 iLab Report
- 640 Words
- 4 Pages
Week 4 iLab Report

The purpose of this lab was to determine the effect of temperature on the volume of gas when the pressure is consistent and to verify Charles’ Law. The data from the experiment reveals that as temperature increases, so does volume. This also indicates that as temperature decreases, the volume decreases as well.…
- 640 Words
- 4 Pages
Good Essays

Read More
Satisfactory Essays
6.03 Calorimetry
- 331 Words
- 2 Pages
6.03 Calorimetry

In order to describe the molar volume of pure water the equation V_3=M_3⁄ρ_(3 ) is used, whereas those of sodium nitrate and the polyether compound poly(ethylene glycol) (PEG) are shown by V_1=V_(∅_1)^∞and V_1= V_(∅_2)^∞. In these two equations, V_(∅_1)^∞ and V_(∅_2)^∞ which are the apparent molar volumes at infinite dilution of sodium nitrate and poly(ethylene glycol), must be computed on the basis of data on apparent molal volume (V_∅). The following equation shows the relation of the V_∅ of a binary solution with density, Equation 1…
- 331 Words
- 2 Pages
Satisfactory Essays

Read More
Good Essays
Tube 2 Lab Report
- 603 Words
- 3 Pages
Tube 2 Lab Report

Figure 1 shows the average amount of absorbance for each tube, containing different levels of pH. Tube 2 had an acidic pH level, Tube 3 had a neutral pH level, and Tube 4 had a basic pH level. It is indicated that the absorbance rates were the highest for the neutral pH level, with a final absorbance rate of 0.166. This was followed by a basic pH (0.106). The acidic pH level had the least amount of absorbance with a final absorbance rate of 0.069. This reinforces the idea that the ALP enzyme worked best under conditions with a neutral pH and worked the least in an acidic pH environment.…
- 603 Words
- 3 Pages
Good Essays

Read More
Satisfactory Essays
Ilab Chemistry Lab
- 451 Words
- 2 Pages
Ilab Chemistry Lab

The purpose of this lab was to determine the atomic weight of magnesium by measuring the amount of hydrogen gas evolved when hydrochloric acid reacted with magnesium. In order to measure the atomic weight I needed to measure the amount of the hydrogen gas that was evolved in reaction to the acid of the magnesium. The reaction used was: Mg + 2HCl --> H2 + Mg2+ (aq) + 2Cl- (aq). The major findings of this experiment were that there was a chemical reaction between hydrochloric acid and magnesium, and the reaction produced the hydrogen gas. The results also indicated how many moles of hydrogen gas were equal to the amount of moles of magnesium consumed.…
- 451 Words
- 2 Pages
Satisfactory Essays

Read More
Satisfactory Essays
How Many Moles Lab Report
- 274 Words
- 2 Pages
How Many Moles Lab Report

1 AND 2 STEP MOLE CONVERSIONS – MORE PRACTICE 1. How many moles does 80.0 grams of H2O represent? 2. How many moles does 45.0 grams of C6H12O6 represent? 3.…
- 274 Words
- 2 Pages
Satisfactory Essays

Read More
Satisfactory Essays
Quiz010: Lab Report
- 929 Words
- 4 Pages
Quiz010: Lab Report

| LabRepQuiz010 Question MC #7: Which of the following is the best written sentence that includes the information below taken from an article written by Dr. Costanza, but avoids plagiarism?…
- 929 Words
- 4 Pages
Satisfactory Essays

Read More
Good Essays
Unit 7 Lab Report
- 680 Words
- 3 Pages
Unit 7 Lab Report

4-6: Why did lung function in the deflated (left) lung return to normal after you clicked Reset?…
- 680 Words
- 3 Pages
Good Essays

Read More
Satisfactory Essays
Year 11 Chemistry Lab
- 531 Words
- 3 Pages
Year 11 Chemistry Lab

A series of measurements are made in order to determine the molar mass of an unknown gas. First, a large flask is evacuated and found to weigh 134.567 g. it is then filled with the gas to a pressure of 735 torr and 31°C and reweighed; its mass is now 137.456 g. Finally, the flask was filled with water at 31.0 °C and found to weigh 1067.9 g. (The density of water at this temperature is 0.977 g/mL.) Assuming that the ideal gas equation applies, calculate the molar mass of the unknown…
- 531 Words
- 3 Pages
Satisfactory Essays

Read More
Satisfactory Essays
Chlorine and Magnesium Lab Introduction
- 286 Words
- 2 Pages
Chlorine and Magnesium Lab Introduction

The purpose of this lab experiment is to determine the atomic weight of magnesium by measuring the amount of hydrogen gas evolved when hydrochloric acid reacts with magnesium.…
- 286 Words
- 2 Pages
Satisfactory Essays

Read More
Good Essays
Absolute Concentration Lab Report
- 1050 Words
- 5 Pages
Absolute Concentration Lab Report

There were six sucrose solutions: 0.0 M (distilled water), 0.2 M, 0.4 M, 0.6 M, 0.8 M, and 1.0 M. The dependent variable was the mass of the cores of apple tissue. Changes in the dependent variable were measured by weighing the mass of each set of apple cores before and after its submerging in sucrose solution. The initial mass was then subtracted from the final mass and divided by the initial mass to calculate the percent change of each set. Changes in the dependent variable were analyzed in the form of percent change of mass rather than change in mass in grams because each set of apple cylinders had a different initial weight, so calculating percent change helped standardize the data. The control of the experiment was the distilled water because it has a molarity of 0.0 M, meaning that no sucrose is added to it. Several variables were held constant. It was attempted to keep the size of each core of apple tissue constant. Other constants include the ruler and scale used to measure the apple cores, as well as the knife used to cut the…
- 1050 Words
- 5 Pages
Good Essays

Read More
Good Essays
molar mass ap chem
- 1051 Words
- 6 Pages
molar mass ap chem

Molar masses, can be seen and used daily in chemistry. In this lab, the ideal gas law helps determine and evaluate the molar mass of gases and volatile liquids. The ideal gas law compares four properties of a gas which include pressure, volume, moles, and temperature. During this experiment, the moles would be unknown, in effect the student must use a substance mass divided by its molar mass. With this, the ideal gas law can be arranged in an equation fit for helping the student determine the molar mass of a gas.…
- 1051 Words
- 6 Pages
Good Essays

Read More
Good Essays
Unknown Acid Titration
- 1249 Words
- 5 Pages
Unknown Acid Titration

The molarity was calculated for part B, the standardization of sodium hydroxide. After all of the molarities were calculated, five of them were accepted and the average came out to be 0.0935, which was the number that would be used throughout the lab to help calculate the molar masses of the unknown acids and the molarity of a soft…
- 1249 Words
- 5 Pages
Good Essays

Read More
Satisfactory Essays
Lab Report 1 Lab Techniques and Measurements
- 1411 Words
- 11 Pages
Lab Report 1 Lab Techniques and Measurements

PURPOSE: The purpose of this experiment is for the students to get a better knowledge with the laboratory tools and techniques. This experiment taught me how to convert between SI units and standard American units of mass, length, temperature, volume and time as well as how to measure the units. Students become proficient in laboratory techniques such as measuring temperature and volume and calculating within them.…
- 1411 Words
- 11 Pages
Satisfactory Essays

Read More
Powerful Essays
Nt1310 Unit 6 Lab Conclusion
- 2742 Words
- 11 Pages
Nt1310 Unit 6 Lab Conclusion

For the purposes of this experiment, the mass will be measured using a digital balance and the volume will be measured directly using a ruler and calculated using the volume formula {fig.1} for a cylinder.…
- 2742 Words
- 11 Pages
Powerful Essays

Read More

Related Topics