Preview

osmosis in gummy bears

Powerful Essays
Open Document
Open Document
2011 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
osmosis in gummy bears
Investigating the effect of different concentrations of glucose on the percent change in mass of Gummy bears according to their respective colours

In this experiment osmosis is the main process taking place. Osmosis is the diffusion of water molecules of a solvent which pass through a semi permeable layer and in most cases are due to a concentration gradient meaning that the water molecules travel from an area of low concentration to one of higher concentration. In this investigation, gummy bears of different colours (dependent variable) were placed in different concentrations of glucose (independent variable) over a certain period of time.In addition to that, the color of the gummy bears was also observed to see if the color could influence the rate of uptake and ultimately the change in mass of the gummy bears. In essence, water molecules from the glucose solution move through the semi-permeable membrane of the gummy bears, thus creating a change in mass of the gummy bear. The controlled variables that had to be established to increase the precision and accuracy of this experiment were the following:
The time in which the gummy bears were placed inside the solutions of glucose: this could increase the number of water molecules passing through the semi-permeable membrane of the gummy bears hence increasing their mass
The temperature of the solutions in which the gummy bears were placed: increasing or decreasing the temperature could eventually lead to a faster/slower osmosis rate knowing that heat increases the rate of osmosis
The concentrations of glucose: These need to be kept constant to keep the osmosis rate constant for the set of concentrations. If not controlled this could result in a change in mass of the gummy bears and less precise results.
The amount of solutions: The volume of water was constant for every trial because if the volumes were not equal for every solution, then it would allow for some gummy bears to take in more or less water molecules

You May Also Find These Documents Helpful

  • Good Essays

    Next, 100 grams of sugar was added to a 250ml graduated cylinder, and then water was added up…

    • 977 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Haribo Gummy Worm

    • 1119 Words
    • 5 Pages

    To weigh each of the gummy bears we used a balance. Each of the three brands was weighed three times. We then submerged one of each type of gummy worm in a 500ml beaker for about 15 minutes. This was to get an accurate measure of their weight, by averaging the average weight before and after they were placed in water. Figure 1.4 shows a representation of the results.…

    • 1119 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Lab for Chemistry 221

    • 612 Words
    • 3 Pages

    Introduction: This experiment was conducted to determine the amount of sugar in a can of Coke and to and use a calibration curve. 5 different solutions were made, each containing 100mL of water and between 1 and 7 grams of sugar. The calibration curve was used to determine the sugar in the can of Coke. The measurements used are grams and milliliters. The calibration curve is used to determine the grams of sugar just by using the density of the can of Coke. In this experiment the main equation was density = mass / volume.…

    • 612 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    nigerias problems

    • 378 Words
    • 2 Pages

    ch bigger and weight more than they were before experiment.The one that got more bigger is the one that was in 20 ml acidic water and 20 ml water.Title:The gummi bears Experiment…

    • 378 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    Gummy Bear Lab Answers

    • 933 Words
    • 4 Pages

    The dependent variable is whether the amount of water lost or gained in the gummy bears varies in a linear fashion. The constants are the type of gummy bear used in this experiment, the type of salt, the type of beaker, the type of scale, the cover, amount of water, and the amount of time the gummy bears have. The control is the beaker without the salt in it; Beaker A. Safety procedures include washing your hands before and after the experiment.…

    • 933 Words
    • 4 Pages
    Powerful Essays
  • Satisfactory Essays

    Gummy Bear Experiment

    • 331 Words
    • 2 Pages

    When you start you should have put the gummy bear in the water and the other in the plastic bag. The one in the water at the beginning of the experiment had a thickness of 9mm a width of 11mm and a height of 22mm and it had a total mass of 2.59grams and a total volume of around 2178 mm 3 The one in the plastic bag is going to be the constant It massed at 2.53 grams and had a height of 21mm a width of 12mm and thickness of 11mm and a total volume of 2772mm3 . We left ours in the water for 24 hours but the one in the bag did not fully diffuse. Because of the semi-permeable membrane that allows certain molecules to get in such as water. Osmosis allows the movement of water to get past the membrane in a cell so that it may get high concentration to low concentration.…

    • 331 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Ap Bio Lab Report Osmosis

    • 850 Words
    • 4 Pages

    of dialysis tubing, 25 mL of sucrose solutions with concentrations of 0.02 Molar, 0.04M, 0.06M, 0.08M, 1.0M, as well as 25mL of distilled water, six 250 mL beakers, a balance, and paper towels. We first cut the dialysis tubing into 6 pieces, each 1ft. long, and placed them into a beaker of water. We then tied off the dialysis tubing and poured 25 mL of distilled water in. We repeated this with the rest of the five pieces dialysis tubing, pouring a different molarity of sucrose solution in different dialysis tubes. After all the tubes were filled and tied, we then dried the bags and weigh each one on the scale. After all the data was recorded, we filled all the beakers about ¾ full of distilled water, placed the bags into each beaker in unison, and waited 30 minutes. Next, the bags were removed from the beakers, dried, and weighed separately. We expected the mass to increase with increasing molarity because with the higher the concentrations, more water would need to be diffused into the bag to reach…

    • 850 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Lab Report

    • 597 Words
    • 3 Pages

    If one places a 1.0 M solution of glucose inside a bag and then places that bag into a beaker containing a 1.0 M solution of sucrose, the percent of mass lost in the bag is 10.5%. The solution in the bag is hypertonic while the solution in the beaker is hypertonic, which is why water moves from the bag to the beaker and the bag loses mass.…

    • 597 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Ap Bio Lab Report

    • 425 Words
    • 2 Pages

    A way to relate this to the real world is that people could use the concept of osmosis to make more accurate administering IVs to put into patients in hospitals. Osmosis is extraordinarily important in the biological processes where the solvent is water. This transport of water and molecules across the membranes is essential to many processes in living organisms and keeping them healthy. In general, this experiment helped understand the different ways osmosis works and how concentration can change the weight of…

    • 425 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    Bag #1 increased the most in size because the solution inside was of a higher concentration of sucrose than that of Beaker #2 so therefore the solution of Bag #1 was hypotonic and water moved into the bag from the solution of the beaker at the greatest rate because it had the highest difference.…

    • 306 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    The purpose of this lab was to observe the rate of osmosis and diffusion, as well as the effect of molecular size of the particles on this rate. Part I of the lab was a demonstration of osmosis and diffusion, that dealt with raisins in different liquid environments, each with a different concentration of sugar. Part IV of the lab was using the same idea as the demonstration, by putting objects in different concentrations of a substance; in this case elodea leaves in salt water. In both cases, the objects in a greater concentration of the substance were stripped of their water. However, where there was a little or no concentration of sugar or salt, the objects did not lose their water, and in the case of the raisin, became saturated with excess…

    • 2315 Words
    • 10 Pages
    Better Essays
  • Good Essays

    Osmosis Lab Report

    • 839 Words
    • 4 Pages

    After the fifty minutes soaking in the solution, the egg placed in water gained mass (Table 1) while the egg placed in syrup lost mass after fifty minutes (Table 2). The percent of mass change was calculated and put…

    • 839 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    * Temperature – The hotter the temperature is the faster osmosis will take place as the particles will move more.…

    • 1599 Words
    • 7 Pages
    Powerful Essays
  • Good Essays

    Gummy Bear Lab

    • 466 Words
    • 2 Pages

    The gummy bear will dissolve in the water due to the fact that most gummy bears are made out of pure sugar. Also that since gummy bears are sugar and sugar usually dissolves in water. Also it will vary due to the amount of water that is used in the experiment.…

    • 466 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    We started setting up our experiment by measuring different molar solutions (0M, 0.25M, 0.5M, 0.75M and 1M) of sugar and putting them into separate bottles, along with one bag (12g) of yeast and 300ml of water. We then attached a tube going from the top of each bottle to separate test tubes which were entirely full of water and were placed upside down in a tub of water, stopping the tube from emptying and…

    • 1723 Words
    • 7 Pages
    Powerful Essays

Related Topics